Default constructor. Sets the following default triangulation parameters: ... more

Distance between knots. This parameter contains the number of additional points between knots; for NURB surfaces it contains number of additional isolines between knots.

Points quantity per edge.

Fast mode is much more faster, but generates more errors.

Recalculate surface tolerance in worldDraw calling virtual 'deviation' method.

Use new tesselation algo for surfaces.

Grid aspect ratio.

Maximum facet edge length.

Maximum number of grid lines.

NormalTolerance allows to specify the tessellation quality of circular surfaces (such as Cone, Torus, Sphere or Cylinder). It is measured in degrees. The value of this parameter determines the quantity of mesh cells (triangles) used to represent a circular surface (360/NormalTolerance). Default value is 15. It means, for an example, that surface will be tessellated with 24 mesh cells (triangles) in circular direction.

Distance tolerance for coincident faces. If zero or negative, the tolerance will be calculated as a percent of extents diagonal: surfaceTolerance = diagonal * fabs(surfaceTolerance), or diagonal * 0.025 if zero.

Comparing operator for wrTriangulationParams class.